4444244
Active Member
- Joined
- Jan 6, 2014
- Messages
- 38
- Reaction score
- 3
Hello,
Following pressure problems in one of my kegs (ie not enough, as discussed on a previous thread of mine), I was advised to try a Co2 injector.
I ordered an injector/cap with valve set from Wilko and also bought 8 gas bulbs. I swapped the regular cap over to the Co2 one and tried to inject the Co2 in the normal way (or so I thought - there are no instructions)
From what I can see, the gas bulb barely touches the pin in the valve - I assume this pin is supposed to pierce the bulb, but it doesn't quite reach even when the injector is fully screwed. I did notice that this pin seems to be loose and actually 'drops' to a lower level when the cap in is place.
Is something glaringly obvious that I'm doing wrong here, as i can't figure out how the get this gas out of the bulb via this valve.
Thanks in advance and hope this all makes sense!!
Following pressure problems in one of my kegs (ie not enough, as discussed on a previous thread of mine), I was advised to try a Co2 injector.
I ordered an injector/cap with valve set from Wilko and also bought 8 gas bulbs. I swapped the regular cap over to the Co2 one and tried to inject the Co2 in the normal way (or so I thought - there are no instructions)
From what I can see, the gas bulb barely touches the pin in the valve - I assume this pin is supposed to pierce the bulb, but it doesn't quite reach even when the injector is fully screwed. I did notice that this pin seems to be loose and actually 'drops' to a lower level when the cap in is place.
Is something glaringly obvious that I'm doing wrong here, as i can't figure out how the get this gas out of the bulb via this valve.
Thanks in advance and hope this all makes sense!!