Southport_sunset
New Member
Hi all, looking to get some advice on the plumbing of a cool box mash tun conversion.
I am thinking:
1/2" hose tail - 1/2" ball valve - 3/4* rubber washer & teflon tape - 1/2" nipple - nut & rubber washer - 1/2" to 15mm - then 15mm copper tube manifold with 3 tees, 4 elbows (push fit).
If anyone could give any advice or right some glaring errors it would be greatly appreciated.
I feel there may be some issues with leakage and also nipple length.
Thermos has two walls and believe is around an inch thick.
Thank you
I am thinking:
1/2" hose tail - 1/2" ball valve - 3/4* rubber washer & teflon tape - 1/2" nipple - nut & rubber washer - 1/2" to 15mm - then 15mm copper tube manifold with 3 tees, 4 elbows (push fit).
If anyone could give any advice or right some glaring errors it would be greatly appreciated.
I feel there may be some issues with leakage and also nipple length.
Thermos has two walls and believe is around an inch thick.
Thank you