Help! my hand slipped with the last 10 mins hops - boil longer, or drain immediately?

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
It all depends on the beer. For an APA or AIPA, you probably won't even notice the difference in bitterness with that little time left. If it's a light lager it might make a small difference. I wouldn't worry personally. I'm sure it will still be a great beer.
 
Too late now but if we're talking 3% noble hops I'd just shrug, say <meh> and continue. If it was 15% Galaxy then I'd probably just stop there and then and call it a big 1 minute addition instead.
 
Just realised that not only did I slip up with the last minute hops (because I mixed up the aroma and bittering - stupid boy, Pike) but when weighing out the hops I followed the recipe (30L) instead of my scaled brew sheet (23L).

What a total and complete muppet. I'm gutted - managed to do everything else right for a change, too... aheadbutt
 
If you've overdone the flameout hops (last 1 minute) no problem at all. Chill the wort and run it off as normal.
Boiling hard, by the way, is the best way to extract the bitterness form the hops.

I think you've got very little to worry about. Continue as normal and all will be fine.
The recipe batch size was 26 litres, by the way, allowing 4 litres to boil off from an initial 30 litres. There's hardly anything in it, in fact.
 
Ohhh KAy....

I think I might have got away with it - there was meant to be a 1 min addition of Southern Cross which I've not now added; so BeerSmith reckons 17.5 IBUs
I reckon it's going to end up quite more than that because the pellet gunge has been sitting in there for about 20min while I've been draining the kettle off - but at least it shouldn't be off-the-scale bitter asad1
 
If you've overdone the flameout hops (last 1 minute) no problem at all. Chill the wort and run it off as normal.
Boiling hard, by the way, is the best way to extract the bitterness form the hops.

I think you've got very little to worry about. Continue as normal and all will be fine.
The recipe batch size was 26 litres, by the way, allowing 4 litres to boil off from an initial 30 litres. There's hardly anything in it, in fact.
That should have been an edit.
Trusting you scaled the malt bill from a 26 litre batch and not a 30 litre. If the latter, you'll end up with a slightly lower OG.
Ohhh KAy....

I think I might have got away with it - there was meant to be a 1 min addition of Southern Cross which I've not now added; so BeerSmith reckons 17.5 IBUs
I reckon it's going to end up quite more than that because the pellet gunge has been sitting in there for about 20min while I've been draining the kettle off - but at least it shouldn't be off-the-scale bitter asad1
It won't be. Late additions count for very little. Unless, they're large and high alpha, I tend to ignore them.
 
FWIW on the basis of what I actually used, BeerSmith reckons the results will be:

Screenshot 2021-07-23 at 15.12.20.png
 
Thanks everyone - OK as usual the answer is: (1) take a deep breath; (2) have a glass of wine; (3) talk to your mates about it (that's YOU lot by the way); and then repeat steps (1) and (2) until you're just laughing about it

🥳
Reach for your copy of The Hitchhiker's Guide to the Galaxy and meditate on the words reassuringly embossed in the front cover.
 
If you can chill the beer at flame out the 10 minute hops won't add that much bitterness. And that bitterness will fade pretty quickly too after such a short boil. Nowt to worry out I reckon.
 

Latest posts

Back
Top