Sorry foxbat, I should have been clearer! I am using the temp sensor to indicate mash temp and the pod is set to manual mode, to control the boil element. I have tested having this set to 100, I have also set it to 90% to check that the element indicator lamp goes off for 1/10 of the time then...
Hi Wobbly, thanks for pitching in!!
I have not had chance to measure the resistance yet but as soon as I do I will feed back. the element is running through an Inkbird pid with SSR, I am assuming that just offers a few more potential points of failure? does this alter the measurement criteria at...
I bought it from angel home brew it’s a 3kw lwd ripple kit they have. I was wondering if it was to do with the fact that it is such a big pot with only a small volume being boiled.
The boilermaker has a lid but from my reading I am understanding that you shouldn’t boil with the lid on anyway is that not correct? I have tried with the lid covering more than half of the opening and it made no difference, it does start to bubble around the element but not a proper rolling...
Hi There, I am quite new to here and very new to brewing, in fact I have not yet completed my build. it is actually built now and I am testing it with just a water run through and hit a snag or two!
I have a Boilermaker G2 for my kettle, it's 115 litre version and I have a 3kw ULWD element in...