Search results

I mashed at 67c so I'm not sure what happened to cause such a low fg, the mash temp wasnt overly low. I guess it's no biggie as it turned out dry and tasting great anyway. Will brew it again and see how it turns out the second time.

I pitched 2 packets of MJ M31 Tripel yeast on my last tripel brew. It went from 1.079 to 1.005 which was a lower FG than planned. I'm thinking of experimenting with 1 packet on the next brew with the possible risk of a stuck ferment if it goes wrong. I read that Westmalle only pitch just over...

There will be a electric element going in to the pot, so there wont be any direct heat outside the pot. Does this look ok? It's the closest copper washer I could fine with a 40mm internal diameter...

So I got the hole cut and the weldless triclamp bulkhead fits in ok. Could do with some advice about getting a good seal. This is the bulkhead fitting I'm trying to install. At the moment I have the silicone seal on the outside of the pot, and went to tighten the nut on the inside of...

Hi. I'm looking to get a pot from Powell brewing. I've bought a weldless tri-clamp bulkhead to fit to the pot. The seller of the bulkhead said it needed a 41mm hole to install. Not sure why they couldn't have made it 40, but that's the problem I now have. The place I bought the bulkhead...

Is it a faff on the Inkbirds to change and adjust in manual mode to control the boil ferocity. I was thinking of just having a switch so i could set the Inkbird pid to heat to almost boiling with an alarm, then just flip a switch to one of those voltage regulators to control the boil from there.