Galena
Landlord.
So today I setup and tested my new re-circulation pump.
I went with a Diablo from Angel HomeBrew and after a short chat on the phone bought enough silicon tubing and the correct Camlock fittings to put it all together.
In fact the longest part of the job was mounting it on a wooden board and the rest took all of 5 mins. Very easy to prime but I am wondering how to avoid getting wort all over the brewhouse when I uncouple. Or perhaps I should install a drain valve at the lowest point so I can siphon into a container?
I will need to get a better way of terminating the outlet pipe, probably an elbow fitted in the lid.
I went with a Diablo from Angel HomeBrew and after a short chat on the phone bought enough silicon tubing and the correct Camlock fittings to put it all together.
In fact the longest part of the job was mounting it on a wooden board and the rest took all of 5 mins. Very easy to prime but I am wondering how to avoid getting wort all over the brewhouse when I uncouple. Or perhaps I should install a drain valve at the lowest point so I can siphon into a container?
I will need to get a better way of terminating the outlet pipe, probably an elbow fitted in the lid.