Help with fixings. Dip tube build.

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Richy25

Well-Known Member
Joined
Sep 12, 2019
Messages
105
Reaction score
19
Hi guys, I'm a beginner at metal work but will get it made eventually!

I have some 1/2 steel tube and tap and would like to convert it into a dip tube to harvest the last of wort from kettle.

I guess I need to fitting's, one elbow and something to attach to 1/2 thread on tap.

Any ideas.

Thanks Richy

IMG_E0207.JPG
 
to connect the tube to the tap rear section all you need is a tap connector

WSZHUsT.jpg


dont solder or braze, just firm puch fit and the same with the nut finger tight will do, easy to break apart to clean afterwards

you want either 1/2" or 3/4" to 15mm which i think is the size of your pipe
 
pipe seems to be 17mm internal diameter. Struggling to find that size.?
 
Are you having the tube angled at the end,pointing upwards at 90 degrees to avoid kettle debris?
If so I'd go with copper fittings...use the tap connection as per hedgerow pete,push fit a length of tube and then push on an elbow.
 
or buy a 1/2" to 22mm tap fitting, that will fit your pipe, if you squeaze the one sideof the copper connector slightly it forms a slight crimp to hold it
 

Latest posts

Back
Top