Lindr dispenser

[Tuckman]

Hi All
New to this site and also to beer dispensing,
So I've bought a lindr beer dispenser and its connected to a Co2 bottle and connected to a kegstar with a session IPA.( Neckoil)
2nd keg so far and the pints seem really good
The keg is installed in our home as a bar setup so the keg is at room temperature.


Question is
If i want to clean the Equipment and line can i simply disconnect and clean then say 1 to 2 week later reconnect to the keg and continue using? Or do i need to reconnect straight after cleaning and apply Co2 again and leave until next use.

Thanks
tom

 

[stripeyjoe]

With my beer lines I clean them with line cleaner, rinse and then push some StarSan solution through. I do the last bit using CO2 and let the CO2 push the majority of the StarSan out. I then leave the lines still attached to their coupler or disconnect with the taps closed to retain the CO2 in the lines.

 

[Tuckman]

So do you leave the keg disconnected then
after cleaning then, or connect and close the valves so the beer doesnt flow back in the line to the lindr

 

[stripeyjoe]

So do you leave the keg disconnected then
after cleaning

I use corny kegs that have separate gas and liquid connections, I leave the liquid one disconnected and leave the gos one connected. when I’ve run a normal keg through my set up I put a on/off valve on the beer line near to the coupler.

 

[scomet]

What did the instructions say that came with the unit? not seen theses before?
I like to leave things cleaned, sanitised, and full of C02.