tazuk
Landlord.
this where i got idea from
ps i used the small drill dit from link
http://www.bohack.com/2010/10/how-to-ma ... n-brewing/
right the main arm is 8mm copper pipe
the upright of sparge arm is 8mm copper pipe
the t section that holds it in one piece is a piece 10mm copper pipe
water in feed is a 15mm to 8mm reducer
as you see on join loads of ptfe tape to hold nut in place and on olive
to seal the bottom of sparge arm and hold the 10mm t section i used contractors sanitary silicon anti-fungal from toolstation its up to you wot you use ??????
holes in sparge arm are as follows
1'' / 1'' /3/4'' / 3/4'' /3/4'' / 1/2'' / 1/4''
here is arm in action
http://www.youtube.com/watch?v=rxEfUvQN ... e=g-crec-u
ps i used the small drill dit from link
http://www.bohack.com/2010/10/how-to-ma ... n-brewing/
right the main arm is 8mm copper pipe
the upright of sparge arm is 8mm copper pipe
the t section that holds it in one piece is a piece 10mm copper pipe
water in feed is a 15mm to 8mm reducer
as you see on join loads of ptfe tape to hold nut in place and on olive
to seal the bottom of sparge arm and hold the 10mm t section i used contractors sanitary silicon anti-fungal from toolstation its up to you wot you use ??????
holes in sparge arm are as follows
1'' / 1'' /3/4'' / 3/4'' /3/4'' / 1/2'' / 1/4''
here is arm in action
http://www.youtube.com/watch?v=rxEfUvQN ... e=g-crec-u