Recent content by djcorbetto

I'd like to enter please

tower...............

What are the electrical connectors being used on this?

Normally he replies to my emails pretty swiftly, I sent him one the other day and also no reply but I did see on his twitter he was in the process of some big changes to the website so perhaps that's distracting him

Why not put the regulator outside of the fridge and then just have the lines going through a hole to the kegs?

So I changed it to a 1000 and it's not working and the guide doesn't really explain whether every sl should be zero apart from the one for heating

Out of interest how did you adjust the pid to take a pt100 probe. I have one and not sure it's reacting well to it

So I dissconnexted the piece of wire and it doesn't work maybe I need to afix a spade connector onto the prong

Oh I think I've seen one of those on eBay and they look awesome

Got any pictures? That sounds massive

that cooler looks bad ass, nice job there, is can it be taken apart to clean or is it just like the popular type of plate chiller.

so on the right hand side where there is a spade connector with a wire soldered to it i just break the wire off and put either live or neutral on that spade connector?

Hi guys, I'm trying to figure out how to connect this element up. It's a burco element in a 6l thermopot as far as I remember there were no cables with it so my simple mind is confused.

It's the software part for me

Fancy giving me a little guide to how you set it up? And the way you connected it to the pi and what you installed? I've got one but it's confused me too much