Grizzly299
The Beer Bear
Hi all, below are a couple photos of my rig as it stands;
Kit:
ã44 - New 27L Cygnet Boiler ( with energy regulator installed instead of stat +ã12)
ã65 - 32.5L Thermo pot
ã22 - 24V Food safe(to 100C) pump with PWM speed controller and power pack.
ã15 - 3 Meters food safe silicon tubing.
Free- Double wound immersion cooler.(Brother is a plumber)
Free- Raised access floor tiles and legs to make the table.
ã50~ Other bits and pieces ball valves,nipples bushes in 1/2in bsp.
I also managed to get some freebie ball valves from the plumbers at work in exchange for a few bottles of the good stuff.
I use the cygnet as a Boiler/HLT and have an intermediate vessel to put the pre-boil wort into before pumping it back to the kettle.
What do you think?
Kit:
ã44 - New 27L Cygnet Boiler ( with energy regulator installed instead of stat +ã12)
ã65 - 32.5L Thermo pot
ã22 - 24V Food safe(to 100C) pump with PWM speed controller and power pack.
ã15 - 3 Meters food safe silicon tubing.
Free- Double wound immersion cooler.(Brother is a plumber)
Free- Raised access floor tiles and legs to make the table.
ã50~ Other bits and pieces ball valves,nipples bushes in 1/2in bsp.
I also managed to get some freebie ball valves from the plumbers at work in exchange for a few bottles of the good stuff.
I use the cygnet as a Boiler/HLT and have an intermediate vessel to put the pre-boil wort into before pumping it back to the kettle.
What do you think?
