Recent content by charlieabbottuk

We use fairy in our copper and then after every 8 brews it gets a deep clean with PBW. The outside just gets a wipe as we go.

Thanks @SteveH Appreciate the advice and wish I knew a friendly electrician. Managed to find another relay which is closer to our original but now with an additional NC terminal. It is only rated at 20a on the NO and 10a on the NC. Not sure which one is better. Pics attached.

Thanks @Bigcol49 I now have lights and no loud bangs! Now to work out how to set the temperature.

Does anyone have a simple wiring diagram that they could share. I have managed to kill 2 Inkbird PIDs (ITC-100VH) following the YouTube clip which was attached earlier in this thread and the wiring diagram attached.

Hi all. Sadly our Cedaronics temperature controller is no longer with us as it decided to melt its relay after 3 years of loyal service. So having bought another relay I thought it would be a simple swap, how wrong could I be as I just cannot find a relay the same as the one we had so my...

I just spotted them too, can't see an issue unless anyone else on here knows differently.

Hi Rodwha Bit of a minefield with temperatures as keeping the mash at different temperatures will give you different outcomes. It is usually best to try and keep at one temperature than a range though, unless you are doing a step infusion, so try to insulate your mash tun as best you can and...

Hi Fil Yes we do recirculate through an external chiller but have a very fine filter fitted under our hop filter and we think that as this gets fuller the pump starts to draw air in from anywhere it can. We are going to remove this and put a finer filter into the mash tun instead. We generally...

Now working, panic over, move along people nothing to see here.

Bit of an update: Managed to find the air leak so the creamy head shouldn't happen again. Going to warm up the fermentation to see if that kick starts things into life.

Hi all hope you can help. The last 2 brews have had this thick creamy residue left in the Boiler during the cold break. It doesn't happen until the last 15-20 mins and up to that point the wort has been pretty clear. The previous 15 or so brews have all been fine and were clear going into the...

Make it £90 and it's yours Kev. Charlie.

In excellent condition, used about 8 times. We have upgraded to a bigger Hop Back so surplus to requirements. Only bought last year for £130 so looking for £80. Complete with instructions. Collect from PE283EG or CB216GH or can courier for about £10 - £15.

We have a more beefy pump and it is that fact that caused ours to block as we were pumping too hard. Now we have the wort flowing from the top we are able to start off slowly and then ramp up to full speed. We still have the hop rocket after our plate chillier so the first few cycles are all...

We only use the smallest size mesh and not the 4" cylindrical part.