Recent content by clampit

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. clampit

    Cleaning Polyropylene

    Thanks will see what the chlorine does first if still persists will trying VSP
  2. clampit

    Cleaning Polyropylene

    No sounds good idea will try tomorrow many thanks
  3. clampit

    Cleaning Polyropylene

    Quite agree kegs sanitised ok it just for cosmetic value only when standing on bar against new units Thanks all for your help 👍
  4. clampit

    Cleaning Polyropylene

    Thanks for that, have already triedOi with no result
  5. clampit

    Cleaning Polyropylene

    Hi all Just brewed Theakston Old Peculiar once again with all dark beers I have trouble cleaning fermenter and barrels after use any suggestions of reviving buckets and keg Jeff
  6. clampit

    White Shield ?

    Hi All In 2016 I posted a picture of a small silver enamel Worthington Shield item asking for an I’d, would you believe the article has just been identified as a Menu Holder crest
  7. clampit

    Worthington White Shield

    Hi all Don't know if anyone can help, I collect pump clips for brews I put on hand pumps, I recently acquired what was stated to de a White Shield Clip, on arrival it was obvious by its size it is no a clip or badge, it is made of brass has enamel inlay and has no evidence of a clip or clasp it...
  8. clampit

    What did you drink ....

    Pint of mixed / Charles Wells bitter and Noggin, and if I was feeling flush it would be a Double Star and Bitter
  9. clampit

    Everyones next planned brew?

    Mine is Snecklifter may try all malt and no invert sugar this time. Have Kingsdown Ale on hand pump at moment :drink:
  10. clampit

    Hi Newbie

    Pic attached
  11. clampit

    Hi Newbie

    Yes reported it to FLO, was registered and able to keep
  12. clampit

    Boiler replacement suggestions

    I have found that my boiler/mash tun takes some beating I use a insulated hot water cylinder cut in half and upturned so use the top half with a short immersion heater in, bent over to be below boil level, I made a thick wooded lid to fit (2inch), when mashing as it is insulated I have found if...
  13. clampit

    Hi Newbie

    Bronze Age axe I would say the firsts one to handle in over 3000 years, just enjoy getting out find are a bonus
  14. clampit

    Hi Newbie

    Hi all Been brewing for around 40 years now retired had a couple of years off due to ill health recently but now back in full swing all full mash beers brewed can be pulled through any of the six pumps in bar
Back
Top