JockyBrewer's latest activity

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  • JockyBrewer
    Well as proven above there already are boots on the ground, and electronic warfare aircraft in nearby airspace feeding target data to...
  • JockyBrewer
    Russia says this about all their weapons, and then if they ever put them in the field they generally turn out to be the same as the old...
  • JockyBrewer
    We have been in a cold war with Russia since the dissolution of the Soviet Union, it just went in to a latent phase for a short while in...
  • JockyBrewer
    JockyBrewer replied to the thread Electric cars..
    Just noticed that the world's largest EV battery maker, CATL, announced back in January that by mid 2024 they will have halved the cost...
  • JockyBrewer
    JockyBrewer replied to the thread Novice water advice!.
    One thing to note with the Hanna alkalinity colorimeters - the reagent has a shelf life, and when you exceed it by too much the tests...
  • JockyBrewer
    JockyBrewer replied to the thread Gas Ball Lock.
    No no, it's for detecting when you're leaking buffalos. :D
  • JockyBrewer
    JockyBrewer replied to the thread Gas Ball Lock.
    Yep, and if any of the six seals in a corny go (lid x1, PRV x1, dip tubes x2, post poppets x2) you can either lose a whole tank of CO2...
  • JockyBrewer
    JockyBrewer reacted to The Baron's post in the thread Gas Ball Lock with Like Like.
    IMO they are only as good as the Oring/Seals
  • JockyBrewer
    JockyBrewer replied to the thread Beer taps and towers..
    Personally I don't rate flow control taps. Either cut your lines to the right length for the pressure/carbonation you're putting in the...
  • JockyBrewer
    JockyBrewer replied to the thread Beer taps and towers..
    On the cheap one the taps are cheap, rear sealing design that lets beer sit in them and go mouldy, or dry up completely and make the tap...
  • JockyBrewer
    JockyBrewer replied to the thread Novice water advice!.
    Hmm. Salifert always was the go to. Took less than a minute to do and got me within 25ppm which was good enough for brewing. I did have...
  • JockyBrewer
    JockyBrewer replied to the thread Novice water advice!.
    I'm curious about this - what do you think your water supplier is adding, and why doesn't a basic alkalinity check allow you to figure...
  • JockyBrewer
    JockyBrewer replied to the thread Gas Ball Lock.
    A can of Buffalo leak detector spray is very useful in this case.
  • JockyBrewer
    JockyBrewer replied to the thread Gas Ball Lock.
    I've got a bunch of Kegland and Keg King grey and black plastic disconnects, as well as some more expensive CMB ones I inherited. Can't...
  • JockyBrewer
    JockyBrewer reacted to Sadfield's post in the thread Novice water advice! with Haha Haha.
    Sensible. I was avoiding adding to the mash to side step certain responses. It didn't work. 😉
Back
Top