Godsdog
Landlord.
Built myself a little router table to do a few things around the house,tried to set it up with the router this afternoon and the rotating tool bit doesn't protrude through the hole in the table enough,the top of the bench table is 18 mm thick,the router us a titan R07W36,that I had gifted to me without instructions,is it a case of removing the springs off the side poles so the router can travel farther up the posts allowing the tool to clear the table hole? Thanks in advance
Edit,the router is a plunge router with 1/2 inch bits that have 30mm long shanks maybe I need extra long shank bits?
Edit,the router is a plunge router with 1/2 inch bits that have 30mm long shanks maybe I need extra long shank bits?