Rich747
Well-Known Member
Had a couple of hours 'off' today so got to work on the first elements of my AG setup. Managed to get a two 40L Buffalos on offer from Nesbits:
First, remove the tap and increase the size of the hole:
Fit the new connector up
And on with the ball valve
A 5mm hole to house the thermometer
In with the connector:
Fit the probe:
How the internals look, works a treat:
Now, on with the boiler - the bits I need. Trimmed the copper Tee and connected it up after installing a ball valve like the one on the HLT.
A test run, all OK!
Next, the mash tun build, then I'll be in business!
Finally, thanks to many people here on the HBF for advice on this, especially Vossy, Baz Chaz, Jonnymorris, Kev, Easy Peasie, Piddledribble and Frisp!
First, remove the tap and increase the size of the hole:
Fit the new connector up
And on with the ball valve
A 5mm hole to house the thermometer
In with the connector:
Fit the probe:
How the internals look, works a treat:
Now, on with the boiler - the bits I need. Trimmed the copper Tee and connected it up after installing a ball valve like the one on the HLT.
A test run, all OK!
Next, the mash tun build, then I'll be in business!
Finally, thanks to many people here on the HBF for advice on this, especially Vossy, Baz Chaz, Jonnymorris, Kev, Easy Peasie, Piddledribble and Frisp!