Brew devil set up & test

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Looks like its working well athumb.. Is that just with using the larger bazooka filter attached to the copper elbow in the pump inlet?? I couldn't quite work out how you are doing it from your previous posts
I use a helix filter, if ' No Chilling' 1 length will do as the wort cools the viscosity rises so a bigger area is needed, so I increased the helix length. I bought them for $3.00 USD each from China. Any budding entrepreneurs could bring them in and make a tidy profit, minimum order 100.
001.JPG

The vertical was a safety guard in case it didn't work but it works fine.
 
I use a helix filter,

I've tried using a standard length helix filter in my old biab pot a few times with zero success - it clogged instantly and was a bugger to get clean inside.
Your's looks like its in a different league though, but have you got it attached to the tap on the side? How are you pumping out?
 
I've tried using a standard length helix filter in my old biab pot a few times with zero success - it clogged instantly and was a bugger to get clean inside.
Your's looks like its in a different league though, but have you got it attached to the tap on the side? How are you pumping out?
Gave up with the pump, put a reducer in the tap and just use that, standard length of helix will not work on cooled wort, the cooler the wort the higher the viscosity, 24 C I tried that worked but was slow, the last one was 27 C and emptied in 20 mins I am going to empty at 30 C next time.
 
Back
Top