mashmaster Thermometer 3" Dial Face- Short Thread

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

paulski

Active Member
Joined
May 18, 2010
Messages
22
Reaction score
1
hi guys i got 2 of these coming from oz for my 2 new shinny pots but was wondering is there anything i need to fit them,ie a nipple or something,how have you guys done it? paul
 
I drilled the appropriate sized hole, used two washes from a2 stainless to sandwich 2 silicone washes cut from a silicone bakingsheet purchased from e bay (cost a few pounds, but makes many). I have never had a leak. And if I go from 50l to 70l I can disassemble.
 
I have done the same except I have cut my sealing washers out of a sheet of waxy feeling gasket board, not tested it yet as I'm still building but if I get any leaks then I'll go for something like silicone baking sheet as the guage is easy to disassemble.
 

Latest posts

Back
Top