My Electric Brewery - Part 2a, The HLT construction

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

chastuck

Senior Member
Joined
Apr 20, 2013
Messages
190
Reaction score
14
Location
Bromley
I’ve started the build on the HLT now, using one of Homebrewbuilder’s high-end 100L pots (http://www.homebrewbuilder.co.uk/). I used a 20.4mm Qmax cutter to cut a ball valve hole 3 inches from the bottom inside of the pot. I am using a weldless fitting to join the valve to the pot and a stainless steel 15mm dip tube for effective draining. The dip tube was bent to 45 deg using a manual pipe bending tool. The dip tube is joined to the valve outlet by using a male SS compression stud coupling 15mm x 1/2" BSP, which screws into a female cone seat union. This method allows me to twist the dip tube into the correct position before tightening the union joint and also allows the dip tube to be easily removed if I want to clean it out. The picture below shows how the tap is assembled.

DSCF1713_zps56316ecd.jpg


This is what the assembled valve looks like on the inside:

DSCF1710_zps2633ab38.jpg


The view of the pot from the outside:

DSCF1711_zpsa6832da8.jpg


Next stages on this pot are fitting a dial thermometer, a sight gauge, a 5500w element and a water input ball valve. Finally, I will attach a water output "T" connection for the temperature probe. Hopefully, more posts tomorrow.
 
AndyBWood said:
Evening Chastuck,

I really like your shiny 45 degree dip tube solution; looks the business :thumb:

A
Thanks. It looks a bit ungainly, but it works a treat. I'm going to use the same method on the boil kettle when I build it and fit the hop stopper in the same way.
 
Looking good mate, following this with great interest:)

Where did you get your stainless fitting from?

Jay
 
Jay7792 said:
Looking good mate, following this with great interest:)

Where did you get your stainless fitting from?

Jay
I got both the union and the compression fittings from BES.
 
That weldless joint looks like a good idea. So those are the only components?
 

Latest posts

Back
Top