ManseMasher
Regular.
- Joined
- Nov 29, 2014
- Messages
- 463
- Reaction score
- 345
Researching how to wire an STC1000, came across loads. This is by far the easiest one for me to get my head around....
I believe they are the other side of a relay, when temp conditions are met these open/close as required, thus applying or removing power to the heater or cooler. They complete the circuit so are essential.I can't see the point of connector 4, 6, or 7, they aren't really doing anything.
I think either solution would be so much easier to read and understand, thank you both for such helpful diagrams. Well timed as I am about to wire my stc1000 :-)
Roy
I built an stc1000 universal heater cooler, it has plug sockets so I can put anything in... used initially for a home made sous vide water bath for cooking, but tempted to put a heating belt/plate on it. ill have to drop the temp sensor in the brew and seal it with a special grommet etc, but had the idea of feeding the wiring through the bubbler.
I would imagine that having the temp sensor submerged in the brew would be more accurate.
having the temp sensor on the outside would measure a combination of the liquid temp and outside temp, proportional to the insulating factor if the container.
Enter your email address to join: