Morning all,
I have just purchased an S30 cylinder, it has plenty of gas. I am using a corney keg with a brass screw thread that I have always just screwed the bottle on to. The last time I used it was around 2014. When I screwed the new bottle on to my older connector, which was fine, no gas came out even when screwed up tight. It appears that my new bottle thread is not reaching the cone to depress the pin in the bottle. Hope I’ve explained that right, any ideas?
I have just purchased an S30 cylinder, it has plenty of gas. I am using a corney keg with a brass screw thread that I have always just screwed the bottle on to. The last time I used it was around 2014. When I screwed the new bottle on to my older connector, which was fine, no gas came out even when screwed up tight. It appears that my new bottle thread is not reaching the cone to depress the pin in the bottle. Hope I’ve explained that right, any ideas?